I know i should have put this thread in the manufacurers section but this is where I put it. Sorry for that. I have had a PM 900 for about 6 years. Recently I had to purchase a new torch cable because thie wires were frayed about 1" behind the torch. Ever since then whenever I need to gouge something I of course change the consumables and when I give it the go ahead it sputters a bit some times it doesn't do anything. I've tried new shields and inspected everything i think possible to fix this prob. But to no availe. Any suggestions?
Reply:Really anyone can answer if there is one out there !!!!!
发表于 2021-9-1 00:45:04