Phase conversion for XMT welder?

admin

I have a three phase welder, a Miller XMT 456, and I was wondering if anyone has used a phase converter to run one on single phase. What setup did you use?I am also wondering what happens if you run the machine directly on single phase? I notice that the drive electronics are all powered by single phase, so I am guessing that the welder might work but with reduced power. I hate to just experiment!
Reply:http://www.millerwelds.com/products/...xmt_456_cc_cv/Says:- requires 3 phase.http://www.phaseconverter.com/City of L.A. Structural; Manual & Semi-Automatic;"Surely there is a mine for silver, and a place where gold is refined. Iron is taken from the earth, and copper is smelted from ore."Job 28:1,2Lincoln, Miller, Victor & ISV BibleDanny