|
|
|
Don't know if this should go here or in the HF section, but this seems as good a place as any.Saw this right angle jig made for holding two pieces at a right angle for welding and the price was right (about 10 bucks). Looked pretty good when I got it home.When I put a couple of pieces of wood in to check how square it was, I found it was off by about a quarter of an inch in 12 inches. Not exactly what I had hoped. Good think HF has a good return policy.Has anyone tried one of these? Is there something I'm missing? There are two scews on each pad that I have no idea what they are for. Is there some easy tune up to get this thing useable?Thanks.Rick |
|
发表于 2021-8-31 23:08:42