Home Made 1 inch square tubing bender

admin

Got this from idea from another poster (unknown) and put it together. It works okay but have to move slowly? Had some scrap Brunel steel had to use up. Could not drill Brunel steel? Plasma cut it instead. LOL Had fun building it, but have not used it yet?  Attached Images
Reply:Didn't even know i came up with something like thatI stand behind my welding, I just won't stand under it!
Reply:*******Last edited by SeanMurphy265; 03-01-2011 at 04:01 PM.Reason: wrong post
Reply:I posted one that is similar back in May 2008 (http://weldingweb.com/vbb/showthread.php?t=21428) but yours is much prettier.For the occasional bending job, these simple benders are hard to beat.  I'll bet yours is going to work just fine.
Reply:Ya JWORMAN, it was your post I got the idea from....Thx Have not used this idea too much yet, but may need it some day? Least I will have it..LOL
Reply:For other low-dollar benders out there, here's a link to a cool article about bending metal:http://www.metalgeek.com/archives/2005/05/01/000047.phpJack OlsenMy garage website
Reply:Originally Posted by Billj0124Got this from idea from another poster (unknown) and put it together. It works okay but have to move slowly? Had some scrap Brunel steel had to use up. Could not drill Brunel steel? Plasma cut it instead. LOL Had fun building it, but have not used it yet?