Beta-Mig 250

admin

Does anyone have a wiring diagram for the beta mig 250.  I had to pull my full wave rectifier out to check it.  Putting it back in I find one small wire I forget where it went.  Either it goes on the post where the Low x-former hooks to the rectifier or on the middle of the hi-low switch.  Anybody out there that has a manual could you either tell me or forward me a copy of the wiring diagram                  Thank you                    no1fisherman
Reply:you still need a owners manual for the unit ??if so send me a email and i will forward it to you .TS2
Reply:I'd like one too for my archives! Kindly send to:logisticslist61ATyahooDOTcomThanks in advance!(Yes, dear readers, it's OK for me to post that address since it's also my Spam Dump and IDGAF who knows it.)Don't ever post an address that isn't expendable or has your name in it!
Reply:i sent it to you this am , sorry for delay i dont visit this site that much .TS2 Originally Posted by farmallI'd like one too for my archives! Kindly send to:logisticslist61ATyahooDOTcomThanks in advance!(Yes, dear readers, it's OK for me to post that address since it's also my Spam Dump and IDGAF who knows it.)Don't ever post an address that isn't expendable or has your name in it!
Reply:Hello and Merry Christmas. I have just acquired a beta mig 250. I cleaned the hi low switch but messed up by not taking a picture of the wiring. A senior moment did not allow me to remember which wire goes where. Any body have a diagram so I don't blow the machine up?
Reply:go to the hobart welder web site and send in a request with your spec number.They will send you the owners manual by email for free.
Reply:A little fuzzy, but maybe it will help.Hobart Beta-Mig 250T-D Cutmaster 81Miller Maxstar 150STLMiller T-Bolt 225 ACChicago Electric Mig 151Hobart RC-256 Haas-Kamp Conversion(sold)