Going to be doing an MSD Shear soon at work. Says this tool must be used. Is it true? How is it done most commonly? Any tips?
Reply:A pic of said tool would help.Ol' Stonebreaker "Experience is the name everyone gives to their mistakes"Hobart G-213 portableMiller 175 migMiller thunderbolt ac/dc stick Victor O/A setupMakita chop saw
Reply:
Originally Posted by GregOdin
Going to be doing an MSD Shear soon at work. Says this tool must be used. Is it true? How is it done most commonly? Any tips?
Reply:For peening a weld an air chipping hammer works better. Had to weld up a crack in a manganese crusher roll with 7/32" Nicromang and had to peen every pass else the manganese would crack alongside the weld.Ol' Stonebreaker "Experience is the name everyone gives to their mistakes"Hobart G-213 portableMiller 175 migMiller thunderbolt ac/dc stick Victor O/A setupMakita chop saw
Reply:I've been using needle scalers and air hammers (using the pointed attachment). for years. Hit it quick and clean, weld and repeat.Lincoln 330 MPXModified TombstoneLincoln LN-25X-TVTMagnum PRO 250LX GT Spool Gun¼ Ton of Torches OFC-A / OFG-ASMAW FCAW GMAW Air Carbon Arc Gouging#Freebird Welds
Reply:I like using wire wheel on 4" grinder. But I was had to pay air compresser so running a grinder off welder was lower cost. Did use hammer too.Dave
Originally Posted by GregOdin
Going to be doing an MSD Shear soon at work. Says this tool must be used. Is it true? How is it done most commonly? Any tips?
发表于 2021-12-19 15:51:30
