Ever get tired of that "righty-tighty" nonsense? Ever throw a wrench across the room after finally figuring out the bolt is a left-hand thread for some godforsaken reason?Well, the Russians have solved the dilemma.
Anyone know what that motorized Makita gadget is?
Reply:So.... a bolt that goes both ways.... I think they already have an acronym for it
Reply:
Originally Posted by VaughnT
Anyone know what that motorized Makita gadget is?
Reply:
Originally Posted by VaughnT
Anyone know what that motorized Makita gadget is?
Reply:Anyone know what that motorized Makita gadget is?[/QUOTE]He said it was a router.
Reply:I was watching that same exact video last night and marveling at the machining. Even though about the only word I understood was him saying "Yes!!" a few times as the bolt freely spun out I really liked it.Millermatic 252 MIGMiller Dynasty 200DX TIGMiller Spectrum 625 PlasmaAltas 12x36 Metal LatheBridgeport Milling Machinewww.psacustomcreations.com
Reply:Watching this was time well spent.
Reply:
Originally Posted by farmersammm
Watching this was time well spent.
Reply:He could have tapped the nut both ways also I thinkCould he then tighten and loosen it clockwise and anti clockwise ?Last edited by Brett; 12-17-2020 at 04:00 AM.A good guess is better than a bad measurement
Reply:Neat for sure. Pretty worthless though for anything practical. The only way it works is with massive pitch. Reduce the pitch to useable and there would be no threads left. That is already weak. Normal pitches forget it.I think a Yankee screwdriver has had threads going both ways for 50 years.Last edited by danielplace; 12-17-2020 at 08:25 AM.
Reply:
Originally Posted by ronsii
Yes, especially the last few minutes of him playing with his nuts
Reply:The original maker made another video where he threaded the bolt in two directions as requested by viewers.Millermatic 252 MIGMiller Dynasty 200DX TIGMiller Spectrum 625 PlasmaAltas 12x36 Metal LatheBridgeport Milling Machinewww.psacustomcreations.com
Reply:
Originally Posted by psacustomcreations
The original maker made another video where he threaded the bolt in two directions as requested by viewers.
Reply:I'm sure I could still cross thread it with an impact wrench.
Reply:Looks like the impact wrench 'crossthreaded' the thread LOL!!!!!502 post fix
Reply:Ah those Russians..............first at EVERYTHING........................NOT! But they got flair when puffing their chests out, and patting themselves on the back
Reply:That is very cool...But 5 days of turning...jeez I wish I had that much free time.I guess if it is below zero for half the year...then 5 days screwing around in the shop aint so bad.
Reply:
Originally Posted by Tarmstrong
That is very cool...But 5 days of turning...jeez I wish I had that much free time.I guess if it is below zero for half the year...then 5 days screwing around in the shop ain’t so bad.
Reply:https://www.mcmaster.com/nuts/self-r...rews-and-nuts/
Reply:
Originally Posted by danielplace
https://www.mcmaster.com/nuts/self-r...rews-and-nuts/
发表于 2021-9-1 23:17:52
