New custom plasma cart.

admin

I posted this on Hobart but for those who dont look there here it is. It dont get any easier than this, not one new screw, not one weld or did I have to add anything. It was a perfect fit. I may add a shelf over the drawer and a door, it may be big enough to slide a welding hood in to keep it out of the dust. Attached Imageswww.urkafarms.com
Reply:Kind of looks like an oscilloscope cart, Tektronix maybe?. Nice find, my plasma cart is an old Hobart mig cart. I was able to place the air compressor at the rear of the cart, where the gas bottle went, by cutting out only one notch so the unit rolls around as one.TiggerAaronHTP Invertig 201w/ CK-20 torch and Bernard ChillerHTP MicroCut 300 plasma cutterLincoln R3S-325 w/ TA 17A Wire FeederVictor Super Range II O/A kitClausing/Colchester 13X40 LatheBridgeport 9X42 Mill