Mig and stick on the same workplace at the same time

admin

Is possibale to run mig and stick to the same workplace at the same time ? Given than one is dcen and other dcep ?
Reply:In short that answer is YesMiller Xmt 350Lincoln Ln-25Ahp 200xSmith Gas Mixer AR/HTig is my Kung FuThrowing down dimes and weaving aboutInstagram http://instagram.com/[email protected]
Reply:Well, yes, as long as we're talking about 2 different machines, not one multi-process machine like an XMT.However, hard-wire MIG is DCEP, and so is most stick welding. Unless you are using self-shielded flux-core, it shouldn't be an issue.JohnA few weldersA lot of hammersA whole lot of C-clamps