Made Myself A Toolbox For Work

admin

I bought a sheet of 16 ga. & some 1-1/2" x 1-1/2" x 1/8" angle & made myself a box to replace my old plywood box, which is partially visible behind the new one, because I was tired of digging through it to find stuff. I put two drawers in the bottom with ball bearing slides & two shelves above them. Also has hangers etc. inside the doors for hanging stuff. I made it at home with my Miller 211.
Reply:Looks good man, it's cool to make your equipment.Tim Beeker.
Reply:Open the doors and take a pic...... I want to see what it looks like on the inside. Qualified & experienced at welding scrap metal
Reply:Originally Posted by little JeepOpen the doors and take a pic...... I want to see what it looks like on the inside.
Reply:X3Nice job!"Where's Stick man????????" - 7A749"SHHHHHH!! I sent him over to snag that MIC-4 while tbone wasn't looking!" - duaneb55"I have bought a few of Tbone's things unlike Stick-Man who helps himself" - TozziWelding"Stick-man"
Reply:Given the Texas state outline next to the US flag and Bevo's outline in the lower right, shouldn't this have been painted burnt orange?....and seriously, open the door and take some pics.  Looks like a great toolbox.  Beats the heck out of a plywood box.  Congratulations.Miller 211 w/ spool gunMiller Dynasty 200DXLongevity 60i IGBT plasmaO/A w/ crappy chinese torch/gaugesSouth Bend 10K latheGrizzly 4029 10x54 millGrizzly 7x12 hor bandsawangle grnders, bench grnder, bench belt sndr7.5 hp 80gal cmprsor
Reply:Not a good pic (cheap *** camera) but here's the inside.
Reply:That's really nice. I'm not going to comment on the Longhorn, but the rest of the box looks top notch! Again good work...Six
Reply:Originally Posted by SixshooterThat's really nice. I'm not going to comment on the Longhorn, but the rest of the box looks top notch! Again good work...Six
Reply:Thats a pretty sweet toolbox. It makes me want to make one too.Ace work dude!
Reply:Could have been worse....could have painted it moron...uh, I mean maroon.Miller 211 w/ spool gunMiller Dynasty 200DXLongevity 60i IGBT plasmaO/A w/ crappy chinese torch/gaugesSouth Bend 10K latheGrizzly 4029 10x54 millGrizzly 7x12 hor bandsawangle grnders, bench grnder, bench belt sndr7.5 hp 80gal cmprsor