My new plasma cart.

admin

It didn't take long to make. Took just a minute to swap it over from the old plasma cart. (shown in front of the new cart)Brian LeonardAppalachian Ironworks L.L.C.434 Long Branch Rd, Marshall, NC 28753828 649 9966828 702 [email protected]
Reply:cutmaster 52 or 82?you will enjoy that cutter. nice machine. i will try get a pic of my cart i made for mine.now you need some cable hangers.JasonLincoln Idealarc 250 stick/tigThermal Dynamics Cutmaster 52Miller Bobcat 250Torchmate CNC tableThermal Arc Hefty 2Ironworkers Local 720
Reply:Originally Posted by snoeproecutmaster 52 or 82?you will enjoy that cutter. nice machine. i will try get a pic of my cart i made for mine.now you need some cable hangers.
Reply:Hey Brian, I bought a 52 from my lws also. It was one that was loaned to a customer, can't tell it was used. I like mine, but as usual- every now and then I could use more amps.PeterEquipment:2  old paws2  eyes (that don't look so good)1  bad back
Reply:I picked up an '09 Cutmaster 52 last week for $600Picked up a new electrode and drag tip from my lws, get home and they don't fit....further inspection, it's a radnor torch. So I had to go to airgas to get new consumables.What did y'all pay for your machines?Aaron
Reply:Mine was a demo unit with less than 3 hours, 2011 model with the TD torch. Full warranty, too.$1300.00 delivered to my shop with about $150 worth of consumables.The cart was free.Last edited by app-ironworksllc; 03-16-2012 at 02:45 PM.Brian LeonardAppalachian Ironworks L.L.C.434 Long Branch Rd, Marshall, NC 28753828 649 9966828 702 [email protected]
Reply:Originally Posted by app-ironworksllcIt didn't take long to make.
Reply:Originally Posted by AMC724I picked up an '09 Cutmaster 52 last week for $600Picked up a new electrode and drag tip from my lws, get home and they don't fit....further inspection, it's a radnor torch. So I had to go to airgas to get new consumables.What did y'all pay for your machines?Aaron
Reply:My cart I fab'd from scrap I had laying aorund. 1" square tube, 1" angle, 1" flat bar and some expanded metal. Had to buy the casters.Last edited by snoeproe; 03-17-2012 at 10:18 PM.JasonLincoln Idealarc 250 stick/tigThermal Dynamics Cutmaster 52Miller Bobcat 250Torchmate CNC tableThermal Arc Hefty 2Ironworkers Local 720
Reply:For a cart, I'm going to do what Brian did...(kinda)Just reuse my old plasma cart (already sold the old one for $600)My whole machine is labeled Randor and the torch model is mc60Aaron
Reply:got pics correct now Attached ImagesJasonLincoln Idealarc 250 stick/tigThermal Dynamics Cutmaster 52Miller Bobcat 250Torchmate CNC tableThermal Arc Hefty 2Ironworkers Local 720