Did a search and found nothing. I am just about to get my used Millermastic 200 running. I was looking at the gun and noticed that the tip sticks out past the noddle end. Is this normal? If so how far should it stick out past the nozzle end?Thanks for your help!!JeffreyLast edited by 1-bad-57; 01-14-2012 at 04:18 PM.
Reply:contact tip stick out depends on joint configuration and user preference be it a lil passed the nozzle or inside itMiller Xmt 350Lincoln Ln-25Ahp 200xSmith Gas Mixer AR/HTig is my Kung FuThrowing down dimes and weaving aboutInstagram http://instagram.com/[email protected]
Reply:Go to miller welds. They have a good thing about stick out. So does Lincoln electricDavidReal world weldin. When I grow up I want to be a tig weldor.
Reply:Thanks for the help guys.Jeffrey
发表于 2021-8-31 23:18:51