Cutting Torch Tip Sizing

admin

Does anyone know where I can find recommended size and pressures for cutting certain thicknesses of steel?  I tried looking on the thermadyne website for a table or chart for sizes, etc.  I have the typical Victor cutting torch.
Reply:I know there's a chart here. Here's a link I found that shows the info also.http://www.hoopersupply.com/tipchart.htmlo.c.d.
Reply:Thats what I was looking for.ThanksMark
Reply:Here is a site that I've used.http://www.torchtools.com/Welding_Nozzles.htmHobart 140 Handler w/ gasHyperTherm Powermax 380 Plasmaoxy/acetylene
Reply:If your LWS doesn't have a tip chart from victor, better find another one. JohnSMAW,GMAW,FCAW,GTAW,SAW,PAC/PAW/OFCand Shielding Gases.  There all here. :
Reply:Scratch this.  I was on the wrong thread.Last edited by tapwelder; 01-26-2008 at 03:15 PM.