make a jig?

admin

how to make a jig?i want to make a jig so i can duplicate my custom turbo manifold, and intake manifold at any time. how would i go about doing this?Lincoln Square Wave 175 TIGLincoln 110v flux core welder (my 1st)Clarke 180EN MIG
Reply:Check out these jigs, maybe you can get some ideas...Bobhttp://www.hobartwelders.com/weldtal...d=1#post327820Bob WrightSalem, Ohio  Birthplace of the Silver & Deming Drillhttp://groups.yahoo.com/group/southbend10k/http://groups.yahoo.com/group/sawking/1999 Miller MM185 w/ Miller 185 Spoolmate spoolgun
Reply:Bolt a plate to each one of the flanges, then weld pieces from each flange to each other, so you can remove the manifold and the flanges stay in place.