Trailblazer 325 arc reach question

admin

Like the title says, I have an issue with my trailblazer 325. When using the extreme 12vs arc reach feeder, which isn't often, I believe it used to stay at idle until you strike an arc then it idled down while welding. Had to get a new board in the feeder and now the tb325 runs at high rpm and only kicks down once welding. Does that seem right? Like I said, i dont use the feeder often, maybe a few times a year to weld 18g door jambs together.
Reply:Had a chance to mess with the machine today. Found out it was my mg remote base being hooked up causing the rpms to remain high. Glad that's all it was.