Overhead Bridge Crane

admin

40 foot wide overhead bridge crane made by Cleveland TramRail, a division of Gorbel. This was a takeout from a light industrial manufacturer.....crane was very lightly used. Looks like the width could easilly be shortened. This was in a clean assembly bay....requires 3 phase 460 volt, has a pendant for control.1 ton rating, end trucks and gantry are motor driven, 1 ton cable hoist, recently inspected. Designed to hang from roof bar joists, all brackets and hardware as well as about 175 feet of longitudinal rail and power track come with it. Located in central New Hampshire....I will load it on your truck. Nice shape.....asking $6500 or best offer.Jim Colt Attached ImagesLast edited by jimcolt; 03-09-2010 at 04:13 PM.
Reply:hey man!... it's the tool-box getter offer... there we go..if you're not livin on the edge, you're takin up too much room..
Reply:I might be interested in this unit. It seems to be wall mounted though. Am I correct?
Reply:Jim he is looking for a system similiar to this one  which is floor mounted Attached ImagesCo-Own CNC shop:Miller :1251 plasma cutter, MaxStar 700 TIG/Stick, & XMT 456 Multiprocess Welder.&  2 Hypertherm HPR260's Plasma CutterSorry I had a bad stroke but now I am back.
Reply:No...the crane actually hangs from roof bar koists....it has brackets that clamp to standard bar joists and rods that hang the rails down. All hardware is included....crane is in excellent shape. You can look it up on the Gorbel Crane site....it is listed under Cleveland Tramrail (Gorbel bought them a few years ago) and is under ceiling mounted cranes I think.  You can contact me directly at [email protected] Originally Posted by pyroracing85I might be interested in this unit. It seems to be wall mounted though. Am I correct?
Reply:Bumped up since several members have inquired about gantry's and Jim still has this one for saleCo-Own CNC shop:Miller :1251 plasma cutter, MaxStar 700 TIG/Stick, & XMT 456 Multiprocess Welder.&  2 Hypertherm HPR260's Plasma CutterSorry I had a bad stroke but now I am back.
Reply:Actually it is sold....I'll have to remove it from the classified section.Jim
Reply:Well congrads on the sale. Someone got a great deal .Co-Own CNC shop:Miller :1251 plasma cutter, MaxStar 700 TIG/Stick, & XMT 456 Multiprocess Welder.&  2 Hypertherm HPR260's Plasma CutterSorry I had a bad stroke but now I am back.
Reply:Originally Posted by monaWhat a nice information. I like this post so much. Because it provide it information threw nice pictures which help to remember about this. I like to share some information about hoist crane, When the crane and hoist is actually lifting equipments, the operator should never leave it hanging for any reason at all. It is important that the operator should set the load down first in a stable position and should be detached from the hook before leaving.Thanks for great sharing.
Reply:Hummm...safety first I guess. Lmao