Hello fellow welders, I've browsed this forum before for knowledge and experience with machines, techniques and help. I'm reaching out for help at this time due to receiving the machine mentioned in the titlethat was taken apart to a degree to facilitate repair. Previous owner said it stopped powering up. I would like to connect all electrical inputs and outputs back to start testing to see where theissue(s) might be. I'm looking for anyone who has this machine and would be able to take multiple pictures under the "hood" and post in this thread? The wires are somewhat densely packedand have white sheaths it makes it hard to get good images of where they run from and where they end up. For starters where does the power cord go to inside the machine? Another place is where does the control panel board (behind the face plate) wires run to?I'd would appreciate any help of advice in this matter.Regards,Bryan
Reply:Power cord goes to the switch.Last edited by Sberry; 5 Hours Ago at 10:30 PM.www.urkafarms.com
发表于 2022-3-2 15:51:19