Hi all,Can any one identify the diode below D51 on a cutmaster 38? I was hoping someone should know this info or have a machine available to check it out.
I picked a cutmaster 38 a little while ago and couldnt get the pilot arc to start so its not cutting at the moment, I swapped out the torch consumables but had no luck.Upon opening the machine I can see that it has had an issue on the board and blown one of the IGBTs and a diode so Im planning to replace and give it another try.
For any one with a similar issue the IGBT is an APT 60GT60BR
发表于 2021-10-23 15:52:19