fittings to adapt a Tregaskiss gun to a Powcon feeder (for spray mode)

admin

I had a Powcon welder until I sold it recently. I can no longer contact the buyer. That welder had a gun which used all the parts from a Tweco no. 0 gun. The gun worked great but I wanted to run spray mode and it would have destroyed the gun. I happened to have a 400 amp Tregaskiss Toughgun which I use sometimes on my Millermatic 252. That gun is rugged enough to run spray mode for hours without burning up. It was a bit of a challenge to change out the Miller back end parts to suit the Powcon feeder. Long story short, I sold the Powcon and kept the Tregaskiss and now I have no use for the Powcon back end for the Tregaskiss gun.I hope this is making sense, it sure seems confusing to me.If you have a need for these Tregaskiss back end parts, PM me and we'll work something out. I'm easy to deal with.metalmagpie