|
|
Hello everyone. I'm new here. I teach welding at a small high school. To make a long story short, the school I'm at has a Hypertherm plasma cutter but no manual. I looked on the internet but could not find one. Anyone know where I can get one?Thanks.
Reply:Jim Colt works for hypertherm I'm sure he can get a digital copy shot right over to you. Post this question there and he will see it.http://weldingweb.com/vbb/showthread.php?t=29041If you cannot convince them, confuse them. Harry S Truman
Reply:Max,If you go to the Hypertherm site and look under resources, you can go to their document library where all the Powermax manuals are located in PDF format.I checked out there site, and an Operator's Manual for the PM 900 is available.This is the site that came up when I searched:http://www.hypertherm.com/library/fi...)/803080r1.pdfHope this helps.Syncro 250 DX Dynasty 200 DXMM 251 w/30A SG XMT 304 w/714 Feeder & Optima PulserHH187Dialarc 250 AC/DCHypertherm PM 1250Smith, Harris, Victor O/ASmith and Thermco Gas MixersAccess to a full fab shop with CNC Plasma, Water Jet, etc.
Reply:You can download the owners and service manuals here!Just type in manual and then select the PM 900 from the drop down for type.https://www.hypertherm.com/Xnet/libr....jsp?locale=en#1. If you don't like what I wrote, or if it offends you, then don't read it!#2. I am living life the way I see fit, if you don't like the way I'M living, tough sh**!
Reply:Max,As the others said....all of Hypertherm's manuals are easily accessible on the www.hypertherm.com site. There are a couple of ways to find them....one is to go to the xnet tab.....for this you will need the serial number from the Hypertherm plasma system.....or you can go to the library tab and find it from there pretty easily. Let me know directly if you have difficulty.Jim Colt [email protected]
Reply:Thanks everyone for the help. I've been needing a manual for this machine and now I have it. I think I'm going to like this site. |
|
发表于 2021-9-1 00:45:05