|
|
One of my projects today, made from 12" 6061 channel, with holes drilled and clips welded on.http://i94.photobucket.com/albums/l1...rkStuff017.jpgHMMMM? the prints say to use E70XX to weld with http://i94.photobucket.com/albums/l1...rkStuff021.jpgPile of cut partshttp://i94.photobucket.com/albums/l1...rkStuff014.jpgI TIGged the clips on(and everything else), the end cap was done with a spoolgun (I didn't start this job)http://i94.photobucket.com/albums/l1...rkStuff015.jpghttp://i94.photobucket.com/albums/l1...rkStuff016.jpgAlmost done, I have 2 more tomorrow.Disclaimer; "I am just an a$$hole welder, don't take it personally ."
Reply:How do ya like the new place Tozzi? Good guys? table flat? Bathroom clean?Where are the stairs going? I have to do a fire escape tommorow."Just take a minute" my boss saysYup
Reply:Great place, good guys, great! bathroomThey are going to a water traatment plant.Disclaimer; "I am just an a$$hole welder, don't take it personally ."
Reply:Looks like a nice shop. and some good work.David Real world weldin. When I grow up I want to be a tig weldor. |
|
发表于 2021-9-1 00:15:28