Welding table vise and grinder mount

admin

Just finished mounting grinder and vise on welding table. I mounted them so i could drop them down to use the total top of the table. Your thoughts? Attached Images
Reply:Very interesting concept..  I wonder how it will work out for you
Reply:Interesting idea, but it looks a bit awkward to use to me, especially the grinder. My 1st thought was it needs some sort of handle to grab, but I don't know where you would put it to be useful.I'm also curious about the big hole in your top. Giant punch bowl holder?.No government ever voluntarily reduces itself in size. Government programs, once launched, never disappear. Actually, a government bureau is the nearest thing to eternal life we'll ever see on this earth! Ronald Reagan
Reply:Nice, I did the same thing a few years back with a Williams Low Buck tube notcher. Didn't use it often but is ready to use " in a flash".Peter
Reply:Originally Posted by DSWInteresting idea, but it looks a bit awkward to use to me, especially the grinder. My 1st thought was it needs some sort of handle to grab, but I don't know where you would put it to be useful.I'm also curious about the big hole in your top. Giant punch bowl holder?
Reply:Nice !... 'That would make a GREAT Plasma Cutting Table with that HUGE Hole in the one side....(Cool Grinder setup BTW...)Cheers,/J...Miller Diversion 165120 amp Buzz BoxVictor Oxy/Ace Oxy/LPGSmith "Little" Oxy/LPGHypertherm Powermax 30Lot's of Misc. tools n' crap....
Reply:Nice idea, interesting way to set up the grinder and vise.  Good idea on the grillework for the open center of the table, too.  Now, you just make a small firepit, mount it on rails so it slides underneath that big hole, and ....