Trying to source a steel post...

admin

Im trying to source a steel post spec'd in some prints i was lookin at. but i have no idea where to find it, i tried lookin at kings, no luckthe post is 1-1/2" square on the bottom then about 10" up, it transitions to round, and then tapers to 1" round on top,I've seen these posts on railings too, anyone have any idea where i could find these posts? http://www.philswelding.com
Reply:Souds like a casting. What's the spec sheet say ?
Reply:the sheet just said the dimensions and basically what i described in my post, http://www.philswelding.com
Reply:Check these guys out.Can't hurt to askhttp://www.morgik.com/Contact_Us_Directions.cfm