A couple approached me said they had a baking business that they run our of their house and needed a heat hood to go over the new convection oven. He brought me a small print of what he wanted and of course needed it yesterday. I do not have a brake at my house and the local fab shop said it would be a week before they could bend up the hood so every seem had to be welded. It came out pretty good the couple was very happy and I was to till I welded the 8" stove pipe flange in and it warped a little but all in all a success. Attached Images
Reply:Nice job!So long as they don't need to pass health code inspections else that might need to be re-done in SS.- MondoMember, AWSLincoln ProMIG 140Lincoln AC TombstoneCraftsman Lathe 12 x 24 c1935Atlas MFC Horizontal MillCraftsman Commercial Lathe 12 x 36 c1970- - - I'll just keep on keepin' on.
Reply:Originally Posted by tackitNice job. Did you roll the 8" chimney flange too?
发表于 2021-8-31 22:49:55