Ran Fabshield 21B for the first time today

admin

This stuff runs NICE! CEP, thanks for telling me about this wire.It is so much smoother than the NR211-MP. The slag completely comes off with one brush of the chipping hammer. This bead was on some 1"x1"x1/4" flat bar. 3 passes, 17v(suitcase readout)@130ipmSent from my SPH-L710 using TapatalkTOO MANY TOOLS & NO MORE SPACE
Reply:Don't mean to tell you what to do, but I'd turn the voltage up, or the wire speed down. I like NR-212 better than NR-211.Don’t pay any attention to meI’m just a hobbyist!CarlDynasty 300V350-Pro w/pulseSG Spool gun1937 IdealArc-300PowerArc 200ST3 SA-200sVantage 400
Reply:Lincoln NR-212 is my go-to FCAW-S wire."Discovery is to see what everybody else has seen, and to think what nobody else has thought" - Albert Szent-Gyorgyi
Reply:I will give it a try with the different settings tomorrow.Figures as soon as I get set up the T-storms move in. Now I'm cutting all of my material to finally finish up this rack in the morning.Sent from my SPH-L710 using TapatalkTOO MANY TOOLS & NO MORE SPACE
Reply:You want it to look something like this. Attached ImagesDon’t pay any attention to meI’m just a hobbyist!CarlDynasty 300V350-Pro w/pulseSG Spool gun1937 IdealArc-300PowerArc 200ST3 SA-200sVantage 400
Reply:Just my experience, but it seemed to me that 21B ran better using a cc source(SA 200) than the NR wires in my 12VS feeder. Using CV power(TB 302) the NR wires seem to be the best choice. Again, Jmo.