Esab 7100 Ultra

admin

Just wondering if anyone here uses this alot. I am looking for approx 1 lb. or so from the end of a spool. I am wanting to try it out for a specific job, but didn't want to buy a full reel. I will gladly pay for it and shipping.Other options are Hobart FabCO Hornet or Hobart Excel-Arc 71.I would prefer .045 but would also take .035. Thanks."Where's Stick man????????" - 7A749"SHHHHHH!! I sent him over to snag that MIC-4 while tbone wasn't looking!" - duaneb55"I have bought a few of Tbone's things unlike Stick-Man who helps himself" - TozziWelding"Stick-man"
Reply:Try the Excel-Arc71 it is a much nicer wire to run. I can spool you off some if you want to give it a try.Disclaimer; "I am just an a$$hole welder, don't take it personally ."
Reply:I really like the esab 710X flux core runs so nice in the vertical position.
Reply:Thanks Tozzi, only reason I prefered the Esab is availability, I think. I have a call in to my Airgas, and the idiot didn't get back to me yet. I just asked for price and availability of the three wires I posted. I didn't think it would be that difficult.Anyways, I'm looking for a wire for welding my rebar chicken ladders. I talked to Ivan from Hobart and also Esab and those were their answers. Lincoln just said NR211MP, which is a E71T-11, same as Hobart 21B. And I already tried 21B, no luck.So yeah, whatever is easiest for you. Either spooling off, or just wait till there is no more than 1 lb. and ship the reel. As always, I WILL be paying you for the WIRE AND SHIPPING. I DO NOT accept charity........... well.......... unless you tell me that you "borrowed" the wire from tbone in the first place!!!  I'm not really in a hurry, so whatever's easier for you. Let me know, and thanks."Where's Stick man????????" - 7A749"SHHHHHH!! I sent him over to snag that MIC-4 while tbone wasn't looking!" - duaneb55"I have bought a few of Tbone's things unlike Stick-Man who helps himself" - TozziWelding"Stick-man"
Reply:I will put some on a little one pound MIG spool and send it off to ya'Disclaimer; "I am just an a$$hole welder, don't take it personally ."
Reply:I DO NOT accept charity.
Reply:Originally Posted by TozziWeldingI will put some on a little one pound MIG spool and send it off to ya'
Reply:Originally Posted by farmallI hear ya. It takes away all the challenge!A "wise" decision.